Configuring Javaterm
Terminal sessions
1
At the system prompt, type SETUP and then press enter.
The REAL/32 SETUP opening screen will appear.
2
Press enter to continue. The current name and location of the system file is displayed.
3
If required, make any amendments and then press enter
to continue. After a few moments the REAL/32 SETUP
Menu will
appear.
4
Use the arrow keys to highlight the "Stations and multiports"
option and then press enter.
5
At the next screen, use the arrow keys to highlight the first available
driver slot. Press enter to move to the select driver screen.
6
Use page down (new drivers are usually added towards the end of the
driver listing. Use the arrow key to select “JavaTerm for TCP/IP driver”
once highlighted press enter.
7
The driver configuration screens that follow have the following fields
which may be amended:
|
Field
Name
|
Default
Value
|
Comments
|
|
Number
of ports
|
1
|
Select
number of ports required.
|
8
When the number has been entered, highlight the Accept field at the
bottom of the screen and press enter
to continue. The port use screen will appear, the following may be amended.
|
Field
Name
|
Default
Value
|
Comments
|
|
1 (this is
the current port number) the total number of ports in this list depends
upon how many ports you have configured in the previous menu)
|
unused
|
A red
flashing “>” denotes the port to
be configured, once selected press enter. Select unused, terminal
or terminal and printer.
|
9
When your selection is highlighted, press enter. The port
configuration screen will appear.
|
Field Name
|
Default
Value
|
Comments
|
|
Number of DOS
sessions.
|
4
|
Select number
required.
|
|
Status line
enabled.
|
YES
|
Displays
status line on terminal screen.
|
|
84 key
enhanced (102 key) keyboard.
|
102
|
Select 102 if
you have an enhanced keyboard.
|
|
Remote mouse.
|
NO
|
Note : This
option is not currently supported.
|
10
When the selections have been made, highlight the Accept field at the
bottom of the screen and press enter
to continue. The disconnection timeout screen will appear. The following may be
amended. Highlight the desired fields and press spacebar to view available
selection
|
Field Name
|
Default Value
|
Comments
|
|
Inactivity timeout period
|
Disabled
|
Disconnects terminal after specified
period of inactivity.
|
|
On timeout
|
Do not disconnect
|
Desired result after timeout period has expired.
Do not disconnect
: Do not disconnect on timeout.
Check before disconnect
: Perform a "ping" type operation to confirm the terminal is truly
dead/turned off before disconnecting the port. This is recommended for LAN
use.
Disconnect
terminal : Disconnect terminal on timeout. This is recommended
for WAN Networks.
|
|
On timeout start line monitor script
|
NO
|
Executes a line monitor script on
timeout, type ‘HELP R32LMON’ at the command line for more information
|
11
When the selections have been made, highlight the Accept field at the
bottom of the screen and press enter
to continue. Repeat the above for each port required. (If all ports are same
configuration highlight the configured port and press F3 then highlight an
un-configured port and press F4. This will copy and paste the settings.
12
When all ports are configured highlight the Accept field at the bottom of
the screen and press enter to
continue on this and the next screen.
13
You will have returned to the Select
configuration area screen.
15
Highlight the “Write configuration
information to
system file” option and press enter, at this screen highlight Exit to
operating system.
16
You will now have to reboot the machine for the Javaterm sessions to become available.
17
When you next load the HTTPD.EXE you should see "Javaterm : driver
loaded"
|